Injen Cold Air Intake Systems

You are probably aware of the basics of the Injen cold air intake: rerouting the air intake outside the engine bay (or at least closer to the front of the car) to gulp cooler air, which is denser, which results in higher power output. So how do the folks at Injen air intake do things differently Light weight is a key attribute to all Injen intake systems. After all, if an Injen intake adds a bunch of weight, it would offset all the extra horsepower. So Injen intakes are constructed of lightweight aluminum and plastic components to minimize weight. Another key to the performance of Injen intakes is the flexibility they provide in routing your system. If you drive in wet weather a lot, your Injen intake will probably need to stay underhood to prevent water damage to your motor. But if wet weather isn't a problem, or you have a full-race vehicle, your Injen intake can route completely outside the engine bay for the coolest air possible. And you can swap your Injen intake between full-length and underhood configurations easily, too. Couple all those design features with the Injen intake velocity stack built in to each Injen intake air filter, and you've got a winning design.   FIND THE INJEN COLD AIR INTAKE FOR YOUR CAR OR TRUCK Select Your Vehicle Make ACURA ALFA ROMEO AUDI BMW BUICK CADILLAC CHEVROLET CHRYSLER DAEWOO DODGE FIAT FORD GMC HONDA HUMMER HYUNDAI INFINITI ISUZU JAGUAR JEEP KIA LAND ROVER LEXUS LINCOLN MAZDA MERCEDES BENZ MERCURY MINI COOPER MITSUBISHI NISSAN OLDSMOBILE PLYMOUTH PONTIAC PORSCHE SAAB SATURN SUBARU SUZUKI TOYOTA VOLKSWAGEN VOLVO       A brief review of all intake systems from Injen. IS Intake Systems The IS Series is a traditional, underhood intake system that is placed in the stock location of the factory air-box system. Each system is built from 6061, T-6 aluminum alloy to ensure the lightest design possible. Every IS system is certified or pending by the California Air Resource Board and backed by Injen Technologys limited lifetime warranty.   EIS Cold Air Extensions The EIS series is a cold air intake extension that adapts on to several of the IS series intake systems. It was developed for the enthusiast who wants the power of a cold air, but also wants the security of removing the extension during wet conditions. Each extension is built from 6061, T-6 aluminum alloy to ensure the lightest design possible. In addition each extension includes a welded bracket for a secure fit. *FILTER NOT INCLUDED RD Series Race Division Intake Systems The RD series is a cold air intake system for the enthusiast craving mid-range power. The intake tube is strategically placed behind the front bumper to acquire colder, denser air. Although most of the RD series is a one-piece design, several are two-piece designs due to the mass air flow meters. Every RD system is certified or pending by the California Air Resource Board and backed by Injen Technology's limited lifetime warranty.     RS Series Rac